Dreytek - Disable SIP ALG

Dreytek - Disable SIP ALG

Issues such as one way audio, lack of incoming calls, registration issues and etc. can be due to the feature SIP ALG


How to Disable SIP ALG

  1. Telnet into the router
  2. Type in sys sip_alg 0 to disable SIP ALG
  3. Type is sys commit to save changes
  4. Type in sys reboot to reboot the router

How to Enable SIP ALG

  1. Telnet into the router
  2. Type in sys sip_alg 1 to enable SIP ALG
  3. Type in sys commit to save changes
  4. Type in sys reboot to reboot the router

    • Related Articles

    • Summit 3CX SIP Trunk Configuration

      Summit 3CX SIP Trunk Configuration This article covers the configuration of a Summit SIP trunk on 3CX PBX and the setup of inbound numbers. Requirements You will need to have the following Provided Summit Internet with the IP of your 3CX Instance ...

    • SIP Trunk Setup and Troubleshooting guide

      Introduction This is a guide to configure your phone systems using Summit's SIP or VoIP account. Implementation Use Cases Third party SIP Phones SIP compatible PBX SIP compatible Gateways, ATA, etc.   Voice Network Figure 1: Enterprise voice ...

    • FlexPBX - Sophos UTM - 9 and Sophos XG Configuration

      FlexPBX - Sophos UTM - 9 and Sophos XG Configuration Known Issues This appliance is a Linux based firewall. Without a correct configuration, they will cause intermittent SIP registration and call quality issues for VoIP based services. This appliance ...

    • Tips to Minimise Data Usage When Using International Global Roaming with Summit Mobile

      Introduction Traveling abroad can be exciting, but high data roaming charges can quickly add up. Here are some practical tips to help you minimise data usage and avoid hefty bills while using international global roaming. Tips to Minimise Data Usage ...

    • FlexPBX Feature Codes

      List of feature codes Here is a list of feature codes you can dial on a phone that is in the FlexPBX system. Call Forwarding Enable Call Forwarding (*72) This feature code is used to exclusively enable call forwarding. The default code is “*72”, and ...